© 2014 Pylon Line
F3D Glow driver with glow intensity set from the TX.
This is our favoured glow driver, the intensity of the glow driver is set from an auxiliary control on the Tx, this means that you must have a spare output on your Rx. The unit is switched on and off via a toggle switch on the Tx such as retracts.
F3D glow driver with button control glow intensity.
This glow driver is used if spare channels in the model are in short supply, the intensity is set by pressing the +/- buttons on the glow driver it’s self, once this value is set it will be stored until changed again. This units switching sense can also be reversed via the push buttons.
|Pylon Line electronics|
|Pylon Line accessories|
|Pylon Line kits and airframes|
|Composite prop tool manufacture|
|Bespoke composite prop manufacture|